ClaraMed Battery/USB light source compatible with ACMI/Olympus/Storz endoscopes
ClaraMedTM Smart Portable LED Light Source compatible with ACMI/Olympus/Storz endoscopes and light cables. S4 Please watch this youtube video for the different adapters that work with this light source and endoscopes supported: https://youtu.be/-pEHVVlQ89o The included adapters support connecting this light source to endoscopes with ACMI thread, and when the adapter is removed, the light source could be connected to storz thread. Another adapter for Olympus endoscopes/light cables, and adapter for connecting to light cables with storz connection.(please review the photos and youtube video).Welcome and thank you for choosing our new ClaraMedTM Smart Portable LED Light Source Features: The ClaraMedTM portable LED light source features double the light intensity than most portable light sources in the market. Now it can be used safely in long surgeries without being worried about battery drainage, thanks to the available external USB power supply. Micro USB power and charging slot makes it easy to charge any time any where with any USB chrging slot. The micro USB slot is not only used for charging, but also for powering the light source, so you do not have to worry about battery drainage in long surgeries. Unlike the mechanical button switch that ruins with time in most portable light sources in the market, the ClaraMedTM smart portable LED light source features a Smart switch button and controller with LED indicator which allows for light intensity control and also gives data about battery charge level and charging status. Standard USB slot for using this light source as a power bank for emergency smartphone charging. The included battery is a genuine PanasonicR battery with a trusted capacity that lasts more than 3 hours “according to light intensity used” and long life span with more than 500 cycles of usage. Dimming circuit for optimal operating light intensity control. Smart circuit that stops charging when charging complete and stops the device when battery is almost empty, so attaining maximum battery protection with longer life span. The following adapters are included:- An accessory adapter for connecting the light source with ACMI endoscopes.- An accessory adapter for connecting the light source with Olympus endoscopes and also light cables with Olympus connection.- Another accessory adapter for connecting the light source with light cables and headlights that have Storz connection Please be noted that Storz endoscopes or endoscopes that have Storz connection can be connected directly with the light source without the need for adapters (please review the pictures) How to use: 1- First time charging: -Upon first use, the battery should be fully charged as it is shipped with only 40% factory charge. -To expose the USB charging slot, rotate the head of the light source counter clockwise. -The LED indicator of the button switch turns red when charging is in progress and turns blue when charging is complete. -Now you can disconnect the charger and start using the device. 2- Using the device: - Connect the endoscope* or light cable** to the light source -Press the power button. . The light will turn on with moderate intensity (this is the recommended intensity for most of examination and long surgeries). -Press the power button again within 2 seconds> .The light will turn to maximum intensity ( this mode is ideal for short procedures that requires intense light - not to be used for more than 10 minutes). -Pressing the power button after 2 seconds from turning on will turn off the device. -When the device is on in any of the above modes, long press the power button with start the dimming feature. Leave the button to keep the desired light intensity. -Rapid 2 press will turn strobe feature on (beta***). -The LED indicator in the power button turns blue when battery is charged, red when it gets weak and flashes red when the battery is empty before the device turns off. *For endoscopes with Storz adapter, please remove the adapter first, then connect the light source to the inner thread of the endoscope. *For Olympus endoscopes, a special adapter should be connected (sold in S3 and S4 models) **For connecting Storz or Olympus light cables, a special adapter should be connected (sold in S2 and S4 models for storz cable, and in S3 and S4 models for Olympus cable)***under development feature. Please note: 1-This light source supports most of rigid and flexible endoscopes,, if you're not sure that your endoscope will work or not please contact us before you make the purchase.2- The included battery is shipped with about 40% charge. Please, fully charge the battery before using it.3- For longer battery life, please do not full charge or fully discharge the battery. 4- If the device is to be stored for a long time, please keep the battery in a partially charged state (about 50%) and do not store it when it is discharged. 5- The light source is not autoclavable. To use the device in clean procedures, wrapping the light source with sterile gloves or other sterile covering will be needed. 6- For protection from overheating in maximum light mode, the light source's power drops to 70% after continuous usage for 5 minutes and keeps on at 70% power. Turning off the light then on again on high mode will restore the 100% power. Technical Data: Brand: CLARAMEDTM Model: S4 Color: Black Material: Aluminium alloy USB Output power: 5V 1A Emitter BIN: T6 up to 10 W Number of Emitters: 1 Color BIN: neutral White (daylight)Color temp.: Approx. 5700K Working Voltage: 3--4.2 VLife cycle of bulb: Approx.10000 h Power Supply: 1 x 18650 Lithium Ion battery or direct USBBattery brand: genuine Panasonic Actual Lumens: up to 1000 lumens Run time: 3-5 Hours (depending on light intensity used) Number of Modes: one press to boot at moderate intensity – press again within 2 seconds gives maximum light - long press 2 seconds: 10%-100%. Quickly press the two times to enter strobe mode(beta) Switch Type: Smart touch switch with LED indicator Dimensions: 13.5 cm x 2.6 cm Weight: 134 g with battery inside Package contents: 1-ClaraMedTM portable LED light source (endoscope/headband not included)2-Accessory adapter for connecting this light source to endoscopes with ACMI thread3-Accessory adapter for connecting Olympus endoscope and Olympus light cables(light cable not included)4-Accessory adapter for connecting light cables and headlights with Storz connection(light cable/headlight not included) 5-Panasonic Lithium ion battery 6-USB cableShipping: Items usually takes 5 to 10 days to be delivered to most countries worldwideWe ship using DHL express, FedEx, UPS, ARAMEX or EMS International Buyers - Please Note: Import duties, taxes, and charges are not included in the item price or shipping cost. These charges are the buyer's responsibility.Please check with your country's customs office to determine what these additional costs will be prior to bidding or buying.Brazil customers: please email us with your "CPF number" when placing your order as its required by the shipping company
